Total Space Required Including Clearance: (W) 25ft/7.6m x (L) 25ft/7.6m x (H) 9ft/2.8m

Ideally outdoors on grass, stakes will be used to hold the unit down. If using outdoors on hard surface we will use sandbags/tethering to hold the unit down, subject to assessment, extra charge will apply. If using indoors we will use sandbags to keep it in place.

This is a heavy inflatable which weighs over 80kg. Ideally we’d prefer to drive right up to where this inflatable is being located. If that’s not possible we’ll move the inflatable from our vehicle using a trolley. Due to its weight, the inflatable will require more than 1 person to be taken up or down stairs, though lifts are usually OK. When rolled, the inflatable can sometimes be over 80CM wide so you should check the widths of doorways / gates / paths and the route you’re planning for us to take. Please let us know if there’s a distance of more than 50m from where we’ll unload / load to where the bouncy castle is being set up.

Please notify Bubble & Bounce of any obstructions i.e. stairs, lifts or no access to power in which a generator would be required

This attraction requires 1 x Standard 240V 13a Plug Socket (like you find at home or in the office). Or 1 x Industry standard blue 240v 16a Commando/CEE sockets. We can provide a generator if required (additional cost applies).

We work in accordance with a Health & Safety Management policy which is regularly reviewed by an external consultant. We covered by a policy which provides £5M Public Liability Insurance cover and £10M employers liability insurance. Each and every one of our attractions is delivered, set up & operated according to our own Risk Assessment and Method Statement which encompasses relevant best practice. All electrical components are PAT Tested at regular intervals and all attractions undergo through safety and quality checks before and after every event. All our inflatables hold either a RPII or PIPA Safety Certification. Just ask for copy documentation.

View our safety pack >
View our risk assessment and method statement >

• The hirer is responsibility to check the items measurements and clearance space. Incorrect measurements could result to a breach of Health & Safety and cancellation of your order with the full balance owed.
• Allow up to 20 minutes before the event for our staff to deliver and set up the equipment, and also 20 minutes after the event for them to pack down and remove the equipment.
• The hirer is responsible to ensure adequate access is available to unload and load equipment. Any restrictions i.e. lack of parking, stairs, narrow doorways etc. MUST be reported prior to your event date. Failure to do so may result in delay to setting up, an additional fee being payable by the Hirer or cancellation.
• The hirer must agree that the area where the goods are to be placed will be free from obstructions & debris.
• We have the right to cancel a booking if the ground surface is unsuitable upon arrival. The full balance will be owed on this occasion.